error code P06dd

[dantheman]

Well the JK has gone back to the dealer on the back off a tow truck, error code P06dd came up yesterday, along with engine light and limp mode, apparently this is a problem with either the oil pressure of the pump stuck in the lowest pressure setting. Anyone else had this come up before?

[limaynard]

Old thread I know but I have / had P06DD and P0369 multiple times since buying a used 2015 JK.

It was under warranty so it has been back to the shop a few times:

For the P06DD the sender was replaced and wiring checked (standard response) but it came back a couple of times. The mechanic seemed to be getting nowhere (despite trying). I took of the PCM connectors and sprayed dielectric contact cleaner in there and put it all back together. Drove it for 250km on various types of road and so far so good.

The P0369 (camshaft position sensor) would come on with the skid light and was intermittent. Mechanic couldn't reproduce but if I drove it for a hundred kms it would trigger. Mechanic cleaned up the contacts, replaced the plugs, traced the wiring, replaced wiring with dodgy resistance (he said low but suspect he meant high) and it was less frequent but it still happened.

The contact cleaner in the PCM connectors seemed to have fixed that too (for the moment)
.

Has anyone else resolved similar issues?

[limaynard]

My P06DD still comes on. Oil pressure is fine, pump and sender have been replaced, it is genuine MOPAR filter, PCM has been replaced.