What did you do to your XJ today? 1M Views

[anthonygubbin]

Originally Posted by rob-rock

Nice clean work Richard
ill be watching how it all go’s together
I’m building a rear bar at the moment, only gotten a far as completing the mounts that go into the uni-frame and pickup all hitch bolts in it. Not very exciting yet
Are you going to weld the angle plates in and then bolt the slider foot on

Hey RR is that your real name or did you take the name from the musician Rob Rock?

Regards A

[Negdriver]

Originally Posted by anthonygubbin

Hey Neg I also think the flares are now required. Tam I bet you wouldn't have it any other way now that you have bit the bullet.

Regards A

As long as everyone is happy


Sent from my iPhone using Tapatalk

[Mudmonster]

made a mount to adapt my bucket seats in my ute project, only got 1 and half done as the power decided to go out.





ill admit im no welder

[Richard buttocks]

Cut one lower rear quarter off

I should probably just start a build thread

[darksidecustoms]

Swapped in the replacement engine wiring loom today. All was ok with the exception of having to solder the old coolant temp sensor plug on - it had been changed for a different plug. Just need to fiddle with the oil temp sensor as I may not have out the cap with the plug back on properly (it had separated previously and came off when I tried to pull the plug off).

[anthonygubbin]

Originally Posted by darksidecustoms

Swapped in the replacement engine wiring loom today. All was ok with the exception of having to solder the old coolant temp sensor plug on - it had been changed for a different plug. Just need to fiddle with the oil temp sensor as I may not have out the cap with the plug back on properly (it had separated previously and came off when I tried to pull the plug off).

Does this mean the loom from Qld arrived DS?

Regards A

[Bleep]

I hit 100,000klm !!