Thanks to Braith7 for this pic, it may be of help to some....
1. Relays - Screw to body near battery
2. Attach to Negative on battery
3. Attach to Positive on battery
4. Plug into existing Driver side Headlamp plug
5. Driver side Headlamp
6. Passenger side Headlamp
7. Driving Light
8. Driving Light
9. For if you want to run the Driving lights on a switch - extend to a switch on the dash - switched to ground.
Use vaseline or similar on all connections, use electrical tape on "4" to seal it to the original socket. Use cable ties or tape to tie the new loom to the original where runs along side, pre-updates run across the top of the grille, updates run across the bottom. The loom pictured is a pre-update loom....
Cheers, JJ