Unfortunately I could not use the rod end seals at this time with my CA's. The washer the rubber bonds measures .050 each side increasing the width .100.
I am going to buy 4 new misalignment spacers and machine down .050 off each.
Not sure if you guys in Aus no of Ruff stuff specialties?
Here's their $100 DIY front upper arm kit.
The factory rubber bushings is cut off. DOM tubing slides over the factory arm and welded w/ a threaded bung. Includes a rod end. I have them set stock to not change caster angle.
http://i1031.photobucket.com/albums/...pscypnw0us.jpg
http://i1031.photobucket.com/albums/...psgccdlr5s.jpg
2007 Rubicon /2 door/6 speed