What are your next mods / What did you do to your TJ today?

[crawl3r]

pulled out the front and rear diff's today and sent them to brian to get all the gear installed, should have it back in the next couple of days was quite fun taking everything out actually, not hard at all, just very time consuming and it would of been a hell of a lot quick with two people but oh well

got everything out eventually and on the truck now the jeeps on axle stands in the garage would be a beast once everything is back in, get the driver side front uni fixed too as it wont seat properly!!! near rear yoke with U bolts going in, 4.56's, overhaul kits and all that

ill get some pics up tomorrow when theres light!

[Richo]

Changed engine oil and filter
Cleaned K&N air filter
removed ARB sidewinder duel battery controller and hooked 2 engine batteries together directly
greased front D44 nitro uni's in prep for next Sundays wheeling
Noted both side front wheel bearings need tensioning up
Did a bit more on hooking up air freespool for winch
tidied up underbonnet wiring.
removed starter and lubed sticky throw out gear with half a can of silicon lube
the list never ends

[D&G Mudhunter]

Finished installing the lights into the mod. I did to the front risers of my wilderness rack.
I didn't want long range out of these lights, i have HIDs on the bar for that, I wanted a cheap, good spread of light when going slow and/or in a convoy.

Also finished the rear box. it has a 100Ahr batt behind the panel. now I just need to decide whether to cover it or just paint it.

Feed back appreciated.

[wes]

Originally Posted by D&G Mudhunter

Finished installing the lights into the mod. I did to the front risers of my wilderness rack.
I didn't want long range out of these lights, i have HIDs on the bar for that, I wanted a cheap, good spread of light when going slow and/or in a convoy.

Also finished the rear box. it has a 100Ahr batt behind the panel. now I just need to decide whether to cover it or just paint it.

Feed back appreciated.

I assume that's an awning on the rack. Nice.

[D&G Mudhunter]

Yes.
It's a foxwing awning from Oztent.

[TJPAUL]

Replaced the rear upper control arms to correct pinion angle after belly lift kit.
New winch ready to fit.

[crawl3r]

im nearly done both diffs are hooked up suspension in, steering connected, waiting on my rear trackbar as im getting it modified so its adjustable then that will go in!

after that all i need to do is bleed the brakes, pour some oil into the diffs and its run in time hope all this effort has been worth it, im so buggered haha