Great,
On the fuses, I have had problems with them looking fine and check out OK with a multi meter....but they were bad.
Now I test with a load across the fuses.
Make a test lamp...grab a 20 watt plus 12 V bulb solder two wires on about a meter long,
One wire put on a small alligator clip you clamp to the car frame negative term of battery. The other wire solder the end cut strands out so it will pock into the small holes in the top of the spade fuse/
The light will shine brightly if all good....or dull if bad connection or not at all if blown.
|