What have you done to your JK this week? 2.5M Views

[tcf]

Originally Posted by xiphos

they are pretty good rack, iv had mine for over a year and a half with no worries. only thing id mention is it might be worth sealing up any holes on the top where you dont put the cross bar in, i got some water in there and later sloshes out a nice rust colour.

Thanks for the tip mate. What did you seal it with? Don't want to silicon if I need to use them. Some sort of rubber plug?

One question for you, what are the six rubber grommets, about an inch dia for?

[xiphos]

I sealed mine up with silicon, ill just dig it out if i need to use it again, i even siliconed up the joints between the bars because i was getting some rust drips there.
A rubber plug should do the job though. I did have a few extra holes in mine from mounting lights on the bar.

no idea what the 6 grommets are for, i didnt get anything like that in my kit.

[tylerzaath]

how much??
where are these roof racks on the DBOR website?
Can't find em anywhere (possibly due to my hangover)

Originally Posted by tcf

Installed the mbrp Rack this morning. Only took 2 hours. Looks well made.

Thanks to Billy and DBOR.

[tcf]

Originally Posted by tylerzaath

how much??
where are these roof racks on the DBOR website?
Can't find em anywhere (possibly due to my hangover)

Haha. There not on the site. This was the first set dbor has shipped. Contact them for a quote. They were by far the cheapest (incl freight) I found.

[tylerzaath]

Originally Posted by tcf

Haha. There not on the site. This was the first set dbor has shipped. Contact them for a quote. They were by far the cheapest (incl freight) I found.

best looking rack I've have seen for the JK without a doubt. Most of the others I've seen look like flower baskets.

Interested to know the static and dynamic load capacity for these (couldnt see the figures on the quadratec website).Would love a setup like this to be able to run a rooftop camper

[oldmacdonald]

Fitted the EFS springs and shocks I've had sitting under the house for nearly a year. I say "the" EFS kit as I believe it was the original JK prototype/testing kit from another forum member.

So far so good, thanks to JasperJ for the motivation and more than helping with the install.

[aussiebulldust]

on the wish list for a mbrp rack but until then, I made this for around $120.00 for the back.

have done a write up in the fab section. (hope thats where it goes)