What have you done to your JK this week? 2.5M Views

[reyzor]

just brought a GME TX 3100, now i just gotta install it...proably friday night. pics will follow

[Fletch]

I just had the new MOPAR 2" Lift Springs to mine and after a weekend in Cobaw Forest I am very happy with the results.
Handles well on the road and certainly reduces the 2 door sway.
Handles most 4WD terrain well even with the standard Jeep shocks.
I thought I would change these really soon but I wont rush just yet.
I have not really flexed it out yet I am sure it will be less articulation than stock but seems all good so far.
Fletch

[JasperJ]

Originally Posted by ShortStuff

Finished fitting ARB Compressor for my Lockers today.
Installed it in the space behind the R/H Tail light, (the Rear Quarter Panel) also ran the rear Diff Breather with Ryco Filter in there too.
(it was a bit like building a Ship in a Bottle!! i.e. its very tight! the compressor wont go straight in and had to be assembled a piece at a time )

Remote mounted the Air Take off to pump up the Tyres in the cargo area just above the Compressor, just plug the hose in when required.

Ran all wiring to new Daystar switch panel.

Power for Comp is coming from a Remco RM12-105FT Battery installed in the Cargo Storage Well.

Happy with the install it turned out quite neat but took 3 days start to finish! ( between scotch and cokes )

Kudos! Nice install there ShortStuff. What did you end up bolting the compressor to?

[wranglertj]

Originally Posted by Fletch

I have not really flexed it out yet I am sure it will be less articulation than stock but seems all good so far.
Fletch

why do you say it will flex less than stock?
Is it because the shocks will run out of travel sooner as not matched to the higher springs or something else?

[Barefoot]

Originally Posted by chameleon

well my TJM bumper is on, looks so much better than the stock bumper, and is 8cm shorter too. Taking it up to Mundaring tomorrow but sadly no time to play in the mud.

You mean it sticks out the front 8cm less? Could you post a piccy from side on ?

oh and whats the price of the TJM bar roughly.. ? Cheers

[Brettski]

Originally Posted by ShortStuff

Finished fitting ARB Compressor for my Lockers today.
Installed it in the space behind the R/H Tail light, (the Rear Quarter Panel)

Impressive. Nice work. I was eyeing that space off as well but the difficulty level is high.

B.

[nic_nac17]

haha nice place to put it i kinda half read the post then ran out to my jeep an started pulling out the back carpet thinking it was under there then confused as i was went back up stairs an read the whole message haha had to go put the carpet back in lmao thanks i think i might look at doin the same haha