What did you do to your XJ today? 1M Views

[junglejuice]

That is pretty cheap.....

[tazwegion]

Thanks that's good to know, still I'd be much happier getting 2 years out of a windscreen rather than 2 months, much prefer to spend the cash on upgrades

[Steve F]

Took off my teraflex disconnects as they were too short, also took off the swaybar relocation bracket (fitted as a band aid for 6 months). Put the swaybar back on the stock mounts and fitted the JKS adjustable disconnects for 4"-6" lifts. Now the tyres don't rub on the swaybar at full lock and the angles on it are set correctly.

Cheers
Steve

[junglejuice]

Today I replaced the rear output shaft bearing on my transfer case, after fitting the H&T SYE I have noticed what seemed like a bearing noise that wasn't there before fitting it and I have used that shaft before and there was no noise previously so fingers crossed it is fixed now.
I will know tomorrow when I take it out for a drive.
Interesting job to do, I had a go at removing the bearing from my spare case on the bench and it wasn't particularly easy to do but the one in the car was a sinch, figure that out!!!!!

[ceven]

Over the last couple of days I've installed an electric fan, fixed the bearing in the aircon compressor (again), fitted a high-lift holder to the spare carrier and repaired a small leak from the thermostat housing.

[Ella]

Put the road tires back on and swaybar links back in. Then went inside and explained to my missus after the awesome days wheeling on Sunday there was no way I would be lowering it for her and in fact it'll be getting lifted lol.
Unsurprisingly she agreed on the terms next time we head out she gets to do a easy hill or two

[sbadman]

Originally Posted by Ella

Then went inside and explained to my missus after the awesome days wheeling on Sunday there was no way I would be lowering it for her and in fact it'll be getting lifted lol.

Good for you!