Decided to replace my Ball joints this morning (OK - had the decision made for me - Whilst driving home last night my front drivers side wheel did its own little death wobble dance- Lol)
So I jacked it up early this morning at work 5am!
Couldnt budge the succer a micro millimeter - so I rang the one and only deadset Jeep Legend / Guru - Dave Woodley "Wooders" and he kindly lent me his ball joint tool!
all seemed to be going well until i realised that i had pressed the bolt outta the top of the ball joint @#@%$@# - is this a bad thing? - see pic below
Anyway with much muttering and swearing I finally got the old ball joint out!
How the hell do you get the new one in??????????? - so I figured if it (the old one) pressed out I could press it (the new one) back in! - easier said than done!
BTW did I mention I that I didnt take off the disc or brakes or pulled out the axel - had some oil leak issues and just recently had the seals replaced so didnt want to disturb them!
OK It was a shed of a job to do in on the lawn at work! lol
but at least I am mobile again!
enjoy laughing at my pix
cheers Hunty
ps
Jk ball Joints & TJ ball joints are the same - cause I just installed TJ joints in my Heap!