Never had transmission serviced-8 speed?

[bjm]

Originally Posted by drover

I did use a modified T40 drive which fitted into a very small ratchet spanner but it took forever to undo so got out the drill, now have a T40 bit welded onto a long hex drive which does the job.......
I use some ramps I knocked up from 3m x 50mm garden sleepers, laid a couple on top of each other, screwed together with batten screws and cut in half with chain saw at angle, one in front of each wheel and drive onto them in LOW and gives me a nice level 100mm lift, so I'm about 140mm higher than standard but am thinking of adding another board so I can roll over easier....... last change I knocked things and gave myself a lube job. Have screwed a block on the end of each one so I have a wheel stop..

Drover the OE ZF pan I got didnt come with new screws .Did you torque the screws as some ZF forums says one use only, geez they arnt that flimsy.!

[drover]

The pan I got did come with new screws last time but not the one before, I really couldn't see why you couldn't use them again, they are solid and not done up that much, only possibility is if the head got chewed out a bit...