Got the replacement indicators into the ARB bar. First pic here you can see why they needed replacement! Also you can see the indicator was put in place then the expanding plastic clips pushed through the lot so when I take out the indicator the clips will come out anyway.
This is the new backing plate in with the clips being pushed through the lot. Takes a bit of fiddling to get it started, I put it in on an angle so one side of the clip was in, then used a flat blade screwdriver to push the other side into the hole then squared it up and pushed it home.
Backing plate in
Indicator just pushes into the backing plate clipping into place with a gentle thump of the fist, job done.
Sent from my GT-I9100 using Tapatalk 2