Tj tie rod ends

[tigermuzza]

I have a pretty bad death wobble at the moment and I’ve narrowed it down to the tie rod ends especially the one that attaches to the steering box. I’m having a little trouble tracking them down. I usually use rock auto for everything but they say there’s suit lhd jeeps. Any help will be awesome

[bonza]

the tie rod ends whether LHD or RHD are the same according to part numbers on the Jeep service manual I have

plus I'm pretty sure I bought a spare set a few years back from rockauto

[ajftj]

recently replaced all of mine, the one that connected to the pitman arm has this part number
52005741
described as left outer, left hand threads Wrangler 91-06
hope this helps

Have to say did you check your panhard rod where it mounts to the axle, ovalled hole here was 90% of my problem.
The ball joint replacement just eliminated the residual nibble after a bump.

good luck.

[Edit - my error]

As I happened to check the part numbers just now, the identification for the part for the pitman arm balljoint is shown as:
52005739 = socket inner (pitman)
When I received my kit of all parts, I was pretty sure I marked them up as I removed them in case I needed the part numbers myself later for replacements.
But from the parts list, looks like I may have made a mistake.
52005741 shows as the balljoint that connects to the hub
52005740 shows at the balljoint that connect to the centre of the drag link

Realise this is some time ago, but wanted to correct for any future reference.

Hope you fixed it already.