So i installed a oricom uhf 180 into the jeep this morning...
Started off by doing this for the main head unit part
The antenna part and where i ran the cable was the best job done i reckon
In the end the antenna was mounted to the rear tire carrier
Another shot
I ran the cable through the same hole that the rear stop light uses
Then ran it behind that bit of plastic on the door to the back...
Then behind the carpet on the side of the interior and behind the seat belt etc to the front footwell
For the rest of the radio itself, I made some spaghetti worst where the stereo goes
Here is the earth for the cb, it is actually a black wire
Here is the main guts part under the dash that contains the speaker, Ive kinda just jammed it under there and put the panel back to hold it
Here is the actual interface where you change the channel and all that also it has the connector for the mic here
Here is another shot from the side
Overall the process was pretty simple, if youve done car stereos before this should be a cinch. The hardest part was finding an earth point for the unit, as you can see i drilled one myself which was a pain in the ass. The jeep seems to have one of the hardest dashes to work on in my experiance.
Enjoy the pics