Axle Straightening Part 2
Thanks Wooders.
The figure I got was from Quadratec from memory. i only looked once when i first noticed it bent and checked there to get an idea of cost before exploring my options.
As to how, well. This is my theory. At the time I was traversing a deep rut. The drivers rear wheel left the ground and started spinning. The wheel dropped and grabbed a rock...one thing the claws do like to grab hold of. I can not put finger on anything else that happened that weekend that could have caused it.
FWIW, I wasn't driving like a dick or going hard in any way, just bad luck.
Oh and the shaft was out .075" or 2mm.
|