recently replaced all of mine, the one that connected to the pitman arm has this part number
52005741
described as left outer, left hand threads Wrangler 91-06
hope this helps
Have to say did you check your panhard rod where it mounts to the axle, ovalled hole here was 90% of my problem.
The ball joint replacement just eliminated the residual nibble after a bump.
good luck.
[Edit - my error]
As I happened to check the part numbers just now, the identification for the part for the pitman arm balljoint is shown as:
52005739 = socket inner (pitman)
When I received my kit of all parts, I was pretty sure I marked them up as I removed them in case I needed the part numbers myself later for replacements.
But from the parts list, looks like I may have made a mistake.
52005741 shows as the balljoint that connects to the hub
52005740 shows at the balljoint that connect to the centre of the drag link
Realise this is some time ago, but wanted to correct for any future reference.
Hope you fixed it already.
__________________
2004 TJ, 4.0L, Manual, finally reliable and fun.
Last edited by ajftj; 25-04-2018 at 11:41 PM.
|