I mounted a Body Armour bar today and an ARB number plate relocation kit, both from DBOR. The stock bar came off OK, it was a bit bent from wheeling so there were a couple of challenges. The SRC bar slides straight into the open ends of the chassis and is then bolted on with 4 bolts.
The numberplate relocation kit was harder work, I had never done auto electrics before so I was learning a lot as I went, it did involve removing quite a few bits of trim but I managed OK in the end. If you do get this one, one thing the instructions don't make clear is that the wire coming from inside the car must go down the centre of the mount for the plate, otherwise the wire gets crushed by the tyre. Apart from that, straightforward but quite time consuming. I'm very happy with the end result.
Once I had finished these tasks I opened the box with the replacement mudflaps in but couldn't work out where they mount so I'll pop into DBOR tomorrow and get some help.
JB