Quote:
Originally Posted by sanchez
Hey Jeepsters can anyone advise me how to install a front crankshaft seal? I took the HB off today and tried to fit a new front seal but realised I need a special tool or DIY tool. Does anyone have any suggestions so I don't have to go and buy a whole new kit? Also some advice on what/how to lube seal etc. before fitting. Thanks in advance guys.
Si
|
The FSM shows a tool that I would replicate using 3/4" drive sockets, threaded rod, washers & nuts. If you dont have 3/4" sockets (very handy as drivers as they range from about 1" to 3" OD in set increments), then you will need to use a short section of pipe