JK: Mitchell Paterson Wrangler build

[037981]

there is a relay and fuse you're right it is a fire waiting to happen have disconnected it in till I get the appropriate electrical gear

[walldog]

Mate, I know it's a Arse load of money on an apprentice wage but have a look at this
http://www.shopwiredhdh.com/servlet/...ems/Categories
Itl save you money in the long run, mine is awaiting me finding a reliable sparky to wire it all together, last bloke can go &@$;?! Himself

[037981]

it looks good but where am I going to put it ?
I will be able to use the daystar switch panel with it not too sure anyone know

[037981]

finally got it on I must say this is most definitely more harder than the snorkel the snorkel was a piece of cake to install

there was a couple of minor issues that I ran into on the spindle housing they forgot to Fred the whole for the zerk fitting so I had to go by a thread tap tool also on the tyre carrier Mount the bolt wasn't long enough for the stock tyre so I had to go to Bunnings in true Bunnings spirit they didn't have the right bolt so I had to go to autobahn thank God they did
other then that everything went together pretty good

[walldog]

Looking good mate, put it under the abs unit, and it should work

[CRDSTU]

Good to see you've got it on Mitch but there's plenty of aligning of the plastic tanks and bar height I can see yet to do!! The gaps should be alot closer than that

Have you also greased the spindle and done a few rotations?

There are 2 bolts on the kit for that tyre holder setup.

So when are you flogging that front bar off so we can get an AEV Premium on there

[037981]

hi Stuart

yes I have greased the spindle pump a lot of inox mx8 GREASE in it and it is working very good

for the alignment I will have a look at it after work tomorrow I see what you mean

mate I like the aev premium front bar but my avenger mako tds 12.0lb winch will not fit in it lol