Hi there I have a 96 XJ 4.0
My issue is the flasher relay...
On the rear end I have replaced all the bulbs with LED's (indicators have load resistors wired in).
Up front I have standard bulbs in the usual places and side markers. I have installed additional LED bulb's in the orange lenses which are not required on the Australian model. (NO load resistors installed yet)
My issue, when using the hazard button, ALL indicators work normal and the relay sounds normal.
Using the turn signal, its like hyper flashing then it stops. I get may be two flashes max.
My gut tells me the relays shot ?
Also I was reading some info on a Narva website about relays. If I understood it correctly, each relay has a MAX number of bulbs that can be on the circuit, is that correct ?. Which can be determined from the info stamped on side of relay.
So I have on each side 2 x LED & 2 x standard bulbs...
All bulbs are working, as I said they work normal on the Hazard button...
Does the 96 XJ use the same relay for the hazard/indicators circuits ?.
Reply's greatly appreciated
regards Rob