|
02-10-2014
|
|
Senior Newbie
|
|
Join Date: May 2013
Location: Parmelia, WA
Posts: 50 What Jeep do I drive?: JK
Likes: 0
Liked 1 Time in 1 Post
|
|
07jkur door wiring diagram
Hello all, I have searched high and low and cannot find any answers on what I am looking for.
I need a door wiring diagram to show me where I can splice in some door down lights that activate when any of the doors open.
I have located the dome light wires that are yellow with a white stripe. But there is no yellow wire in the door kick panel of the drivers door.
There are however, four wires going to the door latch under the kick panel. Black with white stripe, tan with black stripe, green with grey stripe, and purple with white stripe. One of these has to be the one controlling the dome light relay. Can any one help?
Produced by space moneys orbiting planet earth on unicycles.
Sent from space monkeys controlling our satellites! [emoji38]
__________________
Sent from space monkeys controlling our satellites.
|
02-10-2014
|
|
Full Flexer
|
|
Join Date: Dec 2010
Location: Lapstone, NSW
Posts: 1,015 What Jeep do I drive?: JK
Likes: 1,368
Liked 186 Times in 124 Posts
|
|
http://www.jkowners.com/forum/showthread.php?t=51047
These blokes are saying in the passenger door kick panel, which I would also assume to be our drivers side, but, have you checked on the passenger side also?
__________________
2012 JK, Uneek 4x4 front bar, ATV 2.5" flexy coil lift, Maxxis 762 285/70R17, heavy right foot
|
03-10-2014
|
|
Senior Newbie
|
|
Join Date: May 2013
Location: Parmelia, WA
Posts: 50 What Jeep do I drive?: JK
Likes: 0
Liked 1 Time in 1 Post
|
|
Quote:
Originally Posted by WhiteMeat
|
No haven't removed the passenger or right hand door yet. But I would assume the same colour wires are in all four doors.
As the lights I am mounting will be mounted in the door that is where I need to find the right wire to splice.
Produced by space moneys orbiting planet earth on unicycles.
Sent from space monkeys controlling our satellites! [emoji38]
__________________
Sent from space monkeys controlling our satellites.
|
03-10-2014
|
|
MonsterMoose
|
|
Join Date: Jun 2010
Location: Noosa QLD.
Age: 58
Posts: 7,940 What Jeep do I drive?: WK2
Likes: 1,432
Liked 809 Times in 466 Posts
|
|
I would have to double check, from memory the door switches are only providing a signal to the computer and not a traditional style door light switch like 'normal' cars used to have! The dome light itself has 3 wires running to it, an earth and two positives, providing power to the one showing a load which depends on what position the switches at the dome light are at. I did a write up a while ago on it and traced the wiring to the loom between the drivers seat and the door though I cant find it at the moment (new computer...). The really hard part is the wiring in the sound bar is a different colour once it passes through the connector on the drivers side end of the sound bar... Bloody stupid!
__________________
Cheers, Dave :)
2010 JK, then a 2015 KL Trailhawk, now a 2017 GC Trailhawk!
Over 5000 Club
|
03-10-2014
|
|
Lowranger Shocker
|
|
Join Date: Mar 2014
Location: Macarthur Region, SW Sydney
Posts: 1,683 What Jeep do I drive?: JK
Likes: 1,053
Liked 584 Times in 369 Posts
|
|
lol...fit another push button switch in each door frame.....
Just about everything seems to run through the computer controls.....the bloody electric windows, that you'd think would just be a simple up/down switched set up run through the computer.....mine wouldn't come down the other day after I started the car....I didn't panic, I just applied Jeep Wrangler electrical fault finding rule no. 1 - turn the car off completely, restart it...yippee, the windows work again.
Sometimes, I think car designers are way too smart for our good.
|
16-10-2014
|
|
Established Member
|
|
Join Date: Dec 2012
Location: Sunbury
Posts: 158 What Jeep do I drive?: JK
Likes: 15
Liked 14 Times in 8 Posts
|
|
Did you find out which wire to use??
Sent from my SM-G900I using Aussie Jeep Offroad mobile app
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is On
|
|
|
All times are GMT +10. The time now is 01:14 PM.
|
|
|
|
Advertisements
|
|
|