Set up Uneek's Flip Plate holder.
I didn't like the idea of using the alloy number plate as a handle when I wanted to move it, so I cut out some alloy treadplate to use as a plate mount. Another advantage....it covers up the whole winch recess in the bar.
If it doesn't flip high enough, I can trim a little more off the top edge of the treadplate so it'll flip up a bit more.
I also cut off the bottom of the rear bumper and fitted the Smittybilt (DBOR) two bar. Once I got the bumper cleaned up, it takes about 10 minutes to fit the bar....eays as.
Tomorrow, its winch time.