What have you done to your JK this week? 2.5M Views

[GQTRBO]

Fitted a drawer system from Affordable 4x4 Drawers in Dandenong. Comes with a slide out table. I deleted the Sub and bought the panels from the US for the extra room. Also fitted a Outback Solutions cargo barrier. Ironman Fridge sits nicely. Also fitted a Thumper battery system. Just waiting on the custom fridge slide

[Kiwi Jeeper]

[Steve F]

Originally Posted by Kiwi Jeeper

I actually have two PIDs already set correctly for Jeep, pre 2012 and 2012+. These then show up as options on Display list. I went with Transmission Temperature (Jeep 2012 onwards) for my JK. Works great. I'll try to load photos later.

If you managed to get a PID that works for the post 2012+ they'll be plenty that want it, most have only got it to replicate the engine temp, I haven't seen any that have got the correct transmission temperature! Post it on the torque forum

Cheers
Steve

[Kiwi Jeeper]

Originally Posted by Steve F

If you managed to get a PID that works for the post 2012+ they'll be plenty that want it, most have only got it to replicate the engine temp, I haven't seen any that have got the correct transmission temperature! Post it on the torque forum

Cheers
Steve

I'll test it again tomorrow on the way to work against engine temp and confirm.

[dom83]

Originally Posted by GQTRBO

Fitted a drawer system from Affordable 4x4 Drawers in Dandenong. Comes with a slide out table. I deleted the Sub and bought the panels from the US for the extra room. Also fitted a Outback Solutions cargo barrier. Ironman Fridge sits nicely. Also fitted a Thumper battery system. Just waiting on the custom fridge slide

Looks great, could you take a few more pics?

Also if you don't mind sharing what is the drawer system worth?

Sent from my HTC One XL using Tapatalk

[GQTRBO]

Originally Posted by dom83

Looks great, could you take a few more pics?

Also if you don't mind sharing what is the drawer system worth?

Sent from my HTC One XL using Tapatalk

Hi mate, just the drawer system with the slide out table was $850.00 BARGAIN!!! The barrier was $550 I think.

[[NVIOUS]]

Today installed my new GME UHF radio, remote head unit onto Daystar top panel:


Hid the control unit behind the glovebox:


While I was doing the wiring, decided to finally install my Chimebuster too:


Noticed some very small cracks just starting to appear under the hardtop bolts, so got some new clamps to spread the load thanks to DBOR:


Now just have to wait for my PSC antenna bracket to arrive next week.