intercooler hose bracket chipped, need to replace

[JoergM]

Gosh, this car really keeps giving. Now that I was planning to sell it, it decides to act up on me again. So my decision that it will go is made.

On the way back from our sport session, my intercooler hose (the one on the driver side which goes into the turbo) popped out. Looks like the plastic bracket which leads into the turbo chipped off an doesn't hold the hose in place anymore . It is the part where I have to slide the clamp over so that the hose stays in place.

Guess I have to buy a new one, does anymore know the part number for it?

Thanks
Joerg

[JeanLuke]

I went searching through my parts lists. I could not find it, sorry.

[JoergM]

Originally Posted by JeanLuke

I went searching through my parts lists. I could not find it, sorry.

Thanks JeanLuke. I think it is a6460980407. I found some for a 2.1 and 2.2 MB CDI engine but none mention the 2.7 CDI / CRD.

This is how it looks like:
https://www.ebay.com.au/itm/185760180157

[JoergM]

Looks like this is the part: https://www.ebay.com.au/itm/165876671946
This is for a 2.7 CDI with same part number

I just need to make sure if this is is different to Left Hand Driver or a Right Hand Driver...

[JeanLuke]

Found it! Why didn't I think to look under fuel->throttle body in the first place?!

[JeanLuke]

Here you go:

https://www.ebay.com.au/itm/314543464172
or
https://www.ebay.com.au/itm/166009404894

[JoergM]

Thanks JeanLuke. And thanks for the part number. I found one from Italy which brand new too. And a bit cheaper in UK but used.

I will try to glue and plastic weld the chipped part first and see who far this goes. Hope this will last good enough to avoid spending another 200 Dollar for something I am going to sell soon anyway.