3.0 CRD Oil Pressure Sensor Location
Gents,
I have had a dreadful day with the Jeep. Where is the oil pressure switch located on the diesel? Not sure if I have shorted it due to degreasing, or the fact the O ring for the new oil filter was defective and I lost 8 litres of oil in about 500m.
Surely seeing the warning on the dash and shutting the engine down, then filling it up again has been OK? The light was only on momentarily while I discovered the stuff up.
FWIW, the engine sounds fine and isn't rattly while the light is on. I put the regulation 9.5l in both times.
After I degreased all the oil away, I went for a 5km drive and all was good, but after letting it sit for 30 mins then moving it, now the light goes out on start up, but comes on again within seconds after the car is running.
Cheers,
Robert
|