Where have you mounted your UHF?

[RyanG]

Just wondering where everyone has mounted there UHF?

Post pictures if you have any... I'm in the Market for one and was looking for mounting ideas, I was thinking either up on the Windsceen above the rear vision mirror or on the right hand top corner next to the sun visor..... Any one done this?!

[jbrad]

Hey RyanG
I have a GME 3440 mounted underneath the steering wheel. The cover removes to get to the Amp, I mounted it in the space there easily. The mic has the display on it and it is mounted near the right side tweeter so that I can use the function buttons easily while wheeling. My wife doesn't like it because it is out of her reach - although it could have been mounted on the left (spot for the Garmin Nuvi though). I don't have the ability to post pictures.

[TheoB]

I have the GME 3440 with controls on the handset as well. The unit is mounted in behind the plastic covers (in front of my left knee when driving).

[wranglertj]

try a search as you will get heaps of info on this

[anthonygubbin]

Originally Posted by wranglertj

try a search as you will get heaps of info on this

Yerr check my previous posts I have uploaded pics.

[hunty]

Heres a repost from my thread - dig a bit - plenty of people have done amazing things - cheers Hunty

Hi Guyz
I finally got around to installing my CB (cut the cables ties that were holding it onto the top of the dash LoL)
I have looked and looked for a CB with a remote control on the Mic that I could bury behind the dash but alas I could not find 1 that would do both the old 27Meg & UHF - I really get a lot of valuable highway information from the truckers that mainly still use 27Meg - so I decided to see if I could cut my Uniden 95sx dual band (UHF & 27meg) into the top of the panel.

Step 1 Mark it out carefully - LoL
Step 2 Remove the top by prying of the top plastic cover - rear first!
Step 3 Remove - unplug the Compass / direction sensor
Step 4 Using a sharp knife carefully cut out the top of the stereo
Step 5 Same Knife - cut the plastic top
Step 6 Test fit
Step 7 reconnect compass / direction sensor
Enjoy
cheers Hunty

[RyanG]

I did a search and didn't find anything... I figured it would be handy having a heap of info and pictures all in one thread.

But hey there is always the token "do a search" comment whenever just about anyone starts a thread.