LoL......too many questions !!!!
Primarily made of 15mm ply on the base and tops, the sides are 30mm (2 bits of ply stuck together) for strength and fastening of the slides. All glued and screwed together.
I got the slides from the States via Ebay, bit cheaper than anything i could find here. Fastened to the sides with countersunk machine screws and split washers.
Handles and latches are from Concept Lock and latch in Melb.
Will bolt to the floor with 4 pan head bolts and nylocs with AL checkerplate squares as load spreaders.
All trimmed with car "carpet" from Clark Rubber. I over estimated just a little (that means lots
). Might be selling a couple of metres in the near future !!!
I dont have plans as such - just sketches and measurements. Once its in and fitted, i'll upload a basic plan and measurements so you can DIY.
But like i said - its pretty heavy. I HAVE to get new springs in the back other wise im going to be on the bump stops. damn those plastic leaf springs. Merry Christmas to me !!