XJ 2.5 TD injector no.1 needle sensor repair step by step with pics.

[layback40]

Originally Posted by tom.c.coogan

Im from NZ. But can usually buy things from anywhere if you had a link to a size that is small as .08 that would be appreciated.

Cheers
Tom

Sent from my SM-G892U using Tapatalk

If you know an electric motor rewinder, they may tell you who they get their wire from. Some electronics stores may be able to help.

[BrokenJeep]

Hey, ive found some copper wire that is .10mm thk and rewound it with my drill. Now my multimeter shows a reading of around 4 M Ohms which is far too high. Is it possible to get 97ohms with .10mm?

Sent from my SM-G892U using Tapatalk

[amlav]

4Mohm doesn't sound right even with 0.1 wire .

[BrokenJeep]

Thanks, it could be my multimeter? I may try put 97ohm worth of resistance on the plug and see if I can trick it out of limp mode. Wonder if that would have any implications.

Cheers

Sent from my SM-G892U using Tapatalk

[layback40]

Originally Posted by tom.c.coogan

Thanks, it could be my multimeter? I may try put 97ohm worth of resistance on the plug and see if I can trick it out of limp mode. Wonder if that would have any implications.

Cheers

Sent from my SM-G892U using Tapatalk

97ohm resistance wont work with an update. I tried.
You could try checking your multi meter with the 97 ohm resistor.
Sounds like you may have broken the wire when you were winding it.

[BrokenJeep]

Thanks I will give it another rewind. Do you know if .10mm(being a thicker wire) will require more or less coil winds?

Cheers

Sent from my SM-G892U using Tapatalk

[layback40]

Originally Posted by tom.c.coogan

Thanks I will give it another rewind. Do you know if .10mm(being a thicker wire) will require more or less coil winds?

Cheers

Sent from my SM-G892U using Tapatalk

Theoretically it should require the same. I suspect its not that critical.