I bought a taiwanese pipe bender (13mm - 88mm dia cap) last Friday , basically a big jack and dies as I have a few roll cages to build for the Willys and J20
It bends boiler and water pipe beautifully but when I tried to bend exhaust pipe with it I ended up with a crushed and deformed bend
I've heard of using sand in the pipe (how do you seal the ends , weld or wood stoppers ? ) and I've also thought about using a smaller diameter piece of water pipe inside of the tube I want to bend
Any suggestions or ideas ?
This is the only thread I could find on the subject doing a Google search
http://www.the4x4network.com/forum/v...er=asc&start=0