Its been a while, but i have been working and collecting parts. Now i am just about ready to begin the final phases of the project.
Below is a pic of some of my stuffed parts.
The cooling system has a new silicone top hose and older style rubber and inserted spring bottom hose. The rad is a ASI 3 row all ally without tranny cooler. I will go to a HD Mopar if it does not work out. I have a FlowKooler 1747 water pump and new Stant 195F theromstat with new rad cap and thermostat housing.
A Derale 12741 tranny cooler is being installed with fan switch as per GoJeep.
I have a new set of Wildcat extractors (WILD091) to fit in (after they have been ceramic coated) and while i am there, i will fit the new Brown Dog engine mounts and new 50mm brass welch plugs.
New molded heater hoses are being fitted to completely update the cooling system.
There is also a Brown Davies 125 liter long range fuel tank going in, and i have a new o'ring for the back.
Total parts cost including delivery was about $1500 as i got the tank for $200 used. I think i have calculated a bit over 100 hours to fit everything up at my nice slow project pace... including some other bits and pieces i have to finish off.
Then its nearly time for the engineer, who can also check off the tank.