What have you done to your JK this week? 2.5M Views

[aido_3927]

Plus there's another that uses a rubber grommet in the firewall and comes out to the right of where that is. Wires I've fed through there pop out into the footwell.

[MRGC]

Originally Posted by aido_3927

Plus there's another that uses a rubber grommet in the firewall and comes out to the right of where that is. Wires I've fed through there pop out into the footwell.

That's the one I used before but a pain to get to behind the Ecu.

Will try the one above just to save on time, thanx.

[Banshee]

I ran the sPod wiring through that when I put it in this week. You have to use it as the connector wont fit through the other hole. I pulled the grommet out & ran a straightened coat hangar with a hook bent into the end through, into the footwell. Then taped the connector to the hook & pulled it through.

Slit the grommet so the cable can get into the center of it, then reinsert grommet. I had the compressor switch & power for the fridge sockets in the back running through the other hole, but now, just the power as I connected the compressor to the sPod.

I'm tidying up the wiring to the battery while I'm at it. Main problem is that there is not RHD bracket for the sPod Source, so I currently have it stuck onto the top of the fuse box with sticky backed velcro!

[MRGC]

Originally Posted by Banshee

I ran the sPod wiring through that when I put it in this week. You have to use it as the connector wont fit through the other hole. I pulled the grommet out & ran a straightened coat hangar with a hook bent into the end through, into the footwell. Then taped the connector to the hook & pulled it through.

Slit the grommet so the cable can get into the center of it, then reinsert grommet. I had the compressor switch & power for the fridge sockets in the back running through the other hole, but now, just the power as I connected the compressor to the sPod.

I'm tidying up the wiring to the battery while I'm at it. Main problem is that there is not RHD bracket for the sPod Source, so I currently have it stuck onto the top of the fuse box with sticky backed velcro!

Is it a crd or petrol?

[Auscruiser]

Put the soft top back on



Sent from my iPhone using Tapatalk.

[aido_3927]

Originally Posted by Banshee

~
Slit the grommet so the cable can get into the center of it, then reinsert grommet.
~

Exactly what I did! The cable I was using I was able to push through from the firewall side, and it just plonked out on the floor; no coat hanger needed. Same went for the UHF lead

[MRGC]

You guys must have the petrol version, the crd has a few items to negotiate.