Rear bumper/tire carrier
Been wanting to do this for a while now, plan is steel rear bar/swing out tire carrier with two jerry cans hopefully between the tire and tailgate. I picked up a second hand ARB bullbar from an early Range Rover to mod. It allready had the top cut off so saved me a bit of work. I started by removing the mounts, RR must have a very narrow chassis as the mounting points and tapper of the wing's where nowhere near where they needed to be so decided to cut the bar in half and spread it by around 350-400mm while adding a step/cut out for the spare wheel. All mods will be from 3mm like the ARB bar and the mounting plates are 5mm. Had to cut the outer corners off as it was to wide now, I will reshape with 3mm to fill intowards the guard and around the body.
__________________
Formally known as greenjk
|