Hope this question doesn't seem too stupid.
I was under my car today and notice the track bar bushes are flogged out. I looked it up in the manual and it quotes the following:
TRACK BAR
DESCRIPTION
The bar is attached to a frame rail bracket and
axle bracket. The bar is forged and has
non replaceable
isolator bushings at both ends.
I then went on line and found these for $40
http://www.ebay.com.au/itm/231085436...84.m1423.l2649
So my question is........ are the bushes replaceable or not?
has anyone else replaced these bushes?
All feedback would be appreciated