What are your next mods / What did you do to your TJ today?

[Cornelius]

Originally Posted by Kiwi Jeeper

No catches if you have made sure all the parts acquired in advance are correct and matching pieces. I do have the list somewhere stacked away of what all of them were. The most difficult part was getting the old bearings off.

Mate if you could share the parts list that would be Ace ! Please ?

[Squall]

Originally Posted by Kiwi Jeeper

No catches if you have made sure all the parts acquired in advance are correct and matching pieces. I do have the list somewhere stacked away of what all of them were. The most difficult part was getting the old bearings off.

Damn you Kiwi Jeeper, my to do list was getting shorter... Now there is another job to look into...

[tassiecj6]

Originally Posted by Cornelius

Mate if you could share the parts list that would be Ace ! Please ?

x2 !!

[Tassie Jeeper]

Originally Posted by Cornelius

Mate if you could share the parts list that would be Ace ! Please ?

x3...........

[Kiwi Jeeper]

I will put the parts list up, soon.

Went on a trip today, everything worked as intended.

[wes]

Soundbar
A couple of weeks ago, I put some of these LEDs in the Soundbar.
They made a huge difference to the interior lighting even though they were pointing in the wrong direction.

http://www.superbrightleds.com/searc...0wedge%20base/




I noticed these LEDs point straight down, so thought I'd try them out - ordered some and put them in today.

http://www.superbrightleds.com/morei...edge-base/214/



Here's a pic before I put the covers back on - I have a Rugged Ridge Soundbar and had to get creative with a few things but the end result was well worth it



Each 'globe' has 10 LEDs. As expected they put out a lot of light. Actually - a LOT of light
If you are looking for some romantic mood lighting, these are not for you.
A MASSIVE difference over the halogen globes that came with the Rugged Ridge Soundbar.
__________________________________________________ __________________________________________________ __

Underhood
Got a RL (Rigid Loop) LED to replace the RL globe in the underhood light.

http://www.superbrightleds.com/morei...d-festoon/244/



Unfortunately, the LED RL's have the LEDs pointing in the wrong direction for the TJ underhood light fittings so it was time to get creative again.

Had to 'twist' the copper connectors in the light fitting 90 degrees so the LED RL 'globe' could be mounted with the LEDs pointing in the right direction.
Twisting the connectors made them too far apart for the LED, so had to re-route the connectors slightly - Luckily I only broke one plastic clip in this process - cable ties to the rescue



Haven't re-installed the underhood light yet.
After reading the fine print, discovered the RL LEDs are for 'interior use only' so siliconed up all the holes on the light fitting before putting it back in.

[Richo]

Removed all the canvas over the weekend and gave it all a good scrub with the Bestop cleaner to get MOST of the mud stains out.
Also cleaned the interior of mud.
Note to self, dont wheel in heavy mud with only lower half doors.