build sheet for my car

[Mr_TT-89]

Hey guys, anyone know where i can go to get a build sheet using my vin for my car so i know exactly what in it as i have no idea if I've got quadra trak or quadra drive, or what other options were actually put into the car.

[WHHEMI]

All the wh's I've seen with quadradrive 11 have a small badge on the console near the shifter, what year is yours as I think it was standard on the early models then became an option on later ones, I would think if there is no badge you don't have qd11, you could also look at the top of your diffs and see if there are wiring looms connected.

[Clarky]

VIN Decoder
https://jeep.custhelp.com/app/jeep/e...WGxOMmc2T2w%3D

Look at your rear diff cover
Quadradrive II - flat at the bottom with 2 bolts


Quadratrac II - Round with 1 bolt at the bottom

[Mr_TT-89]

due to raining outside i wasn't able to lay down under the car to check out the wiring on top of the diffs but was able to take a few photos from what Clarky has put up photo wise my diff is the same shape as the QDII but theirs no badge near the shifter which is confusing the hell out of me now :S
But my car is a 2005 Jeep GC Laredo 3.0 CRD

One more question to Clarky, that link you put up that lets me put in the cars vin number that gives me a list of standard option and optional options, is that specifically whats been put into my car or is that all the options available for my shape and make so i could have some but some i might not have? as standard its writing QTII but in the options part its writing QDII :S

[WHHEMI]

Is it a Laredo or a Limited

[Mr_TT-89]

its a laredo

[Clarky]

When I put my VIN in it matched what I have, colour, QDII, factory bash plates, sun roof, even the smokers option. So I believe it does show your specific build.

Being yours is an 2005 diesel then yes it is a QDII, when the WH was released in Australia all CRD's came with QDII, this changed some time in 2007.

see http://www.wkjeeps.com/export/wh_export.htm