What have you done to your JK this week? 2.5M Views

[037981]

just picked up 4 new xray 3x 10W LED they look bloody awesome you can stack them on top of and connect them together I got to driving being and to spread being

got them for reasonable price from the show ended up getting them down to 137 dollars each not too bad considering their a brand name

[037981]

Originally Posted by 037981

just picked up 4 new xray 3x 10W LED they look bloody awesome you can stack them on top of and connect them together I got to driving being and to spread being

got them for reasonable price from the show ended up getting them down to 137 dollars each not too bad considering their a brand name

any ideas on how to link the 4 wires neatly together?

[Hotdognz]

Originally Posted by task82

Can you please post up a pic when you have a chance showing where the UHF is mounted?

No picture sorry as I cant see it, but its mounted behind the front center console where the radio is and fan and air-con controls, it seems to be behind the last panel at the bottom tucked away with the mike cord coming up the drivers side, by my left knee.

[drewinmanx]

Originally Posted by Rock God

Ok made a start on my rear metalcloak fenders and exo armour, one stuff up with the nutserts, remember dont torque them to much.





Tomorrow start the other side and if time the rear bar.

Do those guards cover the tyres?

[Rock God]

Originally Posted by drewinmanx

Do those guards cover the tyres?

The rear only just covers very borderline the front does not about a inch short at the widest point but the design of the front fender go's in towards the front which increases the tyre showing. I'm working with metalcloak to design a extension for this problem, a middle section if about two inches should do the trick.

Also I have just +18 back spacing on my wheels with wide 12.5 tyres, now I wish I got the +35 bs wheels that would of helped a lot.

[Rock God]

Originally Posted by 037981

any ideas on how to link the 4 wires neatly together?

Wire them in series, red to red to red to red then out to pos same with the black to earth or earth each one to the light mount. Then you just have one wire to connect to from your switch.

[037981]

Originally Posted by Rock God

Wire them in series, red to red to red to red then out to pos same with the black to earth or earth each one to the light mount. Then you just have one wire to connect to from your switch.

thanks however I was actually meaning was how I could tie lines in together nicely without making a big mess of cable not how to wire them

the factory lead is very short I will work it out

edit I found a way to nicely do it there is a channel that runs along the back of the heatsink