Adjustable control arms

[slayer]

Hey guys,I got a some adjustable control arms coming from wooders and I'm wondering who to take them to to get adjusted??would a general mechanic do the job or should I be going to arb or 4wd specialist????

[Kiwi Jeeper]

You can do it yourself.

[Fat Chili]

Are you talking uppers and lowers, front and rear? Try doing it yourself.....not that hard, how much lift are you putting in will vary the length of the arms and pinion angle needed etc. but a decent general mech should have no issues at all given most of us hacks on here have done it many many times.

[sssadamsss]

Are you talking uppers and lowers, front and rear? Try doing it yourself.....not that hard, how much lift are you putting in will vary the length of the arms and pinion angle needed etc. but a decent general mech should have no issues at all given most of us hacks on here have done it many many times.

Lol hacks. Haha. Too true

[swarzie]

if you are not having any vibrations at the moment make them the same length, do one side at a time and you will need to put a jack under the spring plate or the pinion depending which way you need to line up the bolt holes. if you have lifted your jeep chances are you will need to tilt the pinion up a little.

[slayer]

Hey fat chili.yeah I got front and rear,upper and lower.ive got 2.5" ome lift.
I have no concerns putting them in,just the adjusting side of things

[slayer]

Cheers swarzie!!no real vibes goin on.
So I spose I'll just give it a go and see wat happens

[Uncle]

given most of us hacks on here have done it many many times.
I'm not a hack I am more of a block splitter! :p