MML's - Who has what ??

[Moses]

Looking to fit a motor mount lift very soon

just wondering who has what and if you are happy with it

also where did you get it and the cost ??

thanks
Moses

[slayer]

I got a 1" set of curries from jeep konnection.95 bucks I think,but can't really comment as not installed at the mo.they look very well manufacted though

[kennyboy]

my tj had 1 1/2" mml. 1" higher currie engine mounts (ebay) and a 1/2" spacer underneath that.
i did this to allow me to lift the gearbox/transfer higher to do belly up belly pan.
but i had a 2" bl aswell.
from memory the new engine mounts were less than $100 and i made the spacers myself.

[Moses]

my tj had 1 1/2" mml. 1" higher currie engine mounts (ebay) and a 1/2" spacer underneath that.
i did this to allow me to lift the gearbox/transfer higher to do belly up belly pan.
but i had a 2" bl aswell.
from memory the new engine mounts were less than $100 and i made the spacers myself.

this is the reason i want to do the MML, i too have a 2" BL already

[kennyboy]

this is the reason i want to do the MML, i too have a 2" BL already

i actually lifted the gearbox/transfer the full 2" to line up with the original brackets and put the gear lever back in its original spot.
its not ideal but because it makes your drive line angles worse and we all know tjs dont need any help in that area.
i made my own belly up, and it had a 6mm bash plate.
the highest i could get it was a little over 1 1/2" away from the chassis rails, i dont see how anyone can claim to have a dead flat belly plate. it simply isnt possible, well i could be flat but not level with the chassis.

[Moses]

would love to see pics of your set up Kennyboy

[Kiwi Jeeper]

I ran M.O.R.E. poly 1" MML but didn't like the vibrations from engine coming through the frame. So changed to these:

http://browndogindustries.com/CU2883-1-Jeep-Wrangler-TJ-6-Cylinder-1-Inch-Motor-Mount-Lifts-Rubber.aspx

http://browndogindustries.com/images/products/thumb/CU25721CroppedFinal.1.jpg

These are rubber bushing, very happy with them. They now make them in 1.5" height as well. Since they ship overseas, got directly from them.

[Moses]

getting some Currie 1" MML

[Bogged]

We have M.O.R.E. Rubber mounts (These use a standard control arm bush) in stock and can get Rubicon Express or JKS.

[anotherblacktj]

Got the more 1inch riser mounts to

[carlosprite]

I have the MORE Torsion Bomb-Proof Rubber mounts, they seem decent, better than my broken stock ones ;)