Tie Rod End Thread Type?

[Rosie]

Hey guys, just wondering if anyone could tell me the thread on the Tie Rod End at the Pitman Arm end of the Drag link of a TJ. Even better, can anyone link me to a Tie Rod End to suit?

I'm actually chasing it to use in conjunction with a "Wooders" Adjustable Panhard ad part of my Panhard drop setup.

Cheers, Ben

[Bogged]

??? One are the same. Fairly certain Wooders would have them in stock.

[rhysTJ]

as in left or right hand thread?? could look tomorrow for ya if no one chimes in

[Jonny Jeep]

Here's what's listed on Moog site for the TRE at the pitman arm...

Moog ES3096L Part Dimensions

Length---Rod Thread Dimensions---Configuration---Rod End Type---Stud Small Taper---Stud Large Taper---Stud Thread Dimensions
5.37 --- M22 x 1.5 LH Thread----- Bent --------- Male ----------- .558 ------------- .626 -------------- 1/2-20

[Wooders]

??? One are the same. Fairly certain Wooders would have them in stock.

Correct (http://www.wooders.com.au/index.php?main_page=product_info&cPath=525&products_id=5191) :D

[Rosie]

Ahh, I had another post but it's gone missing.

I am not after a convectional Tie Rod End, I am actually after a Heim joint to use along with my SkyJacker Panhard Drop in a double sheer, horizontal plane setup.

The skyjacker one uses a bush at the chassis end and the heim at the Diff end but i still have a small amount of fouling.