Finally we found some time to fit the TeraFlex High Steer Knuckles to our RHD JK and at the same time give the axle some TLC and service the RCV axles which after 50000km still look good. Now we already had a high steer setup via drilling the knuckle so we had no other modifications to do at the same time. But if you were to run this setup you will need a minimum of 4" lift and also you will have to either drop at chassis or raise at axle your track bar. Also we are running the Currie draglink and tie rod and these are very big so it might look a bit tight compared to other setups. We have tested it on road and there are no issues, we will be testing it off road to confirm that it has clearance all around.
TeraFlex RHD High Steer
