AUSJEEPOFFROAD.COM Jeep News Australia and New Zealand - Search Results

Go Back   AUSJEEPOFFROAD.COM Jeep News Australia and New Zealand > Search Forums
Register Forums Trading Your Jeep My Garage Mark All Read

Showing results 1 to 20 of 63
Search took 0.01 seconds.
Search: Posts Made By: Macca007
Forum: JK Wrangler Australia 29-09-2011
Replies: 14
Views: 2,511
Posted By Macca007
07 CRD manual 60.000 just did a 'thrust bearing'...

07 CRD manual 60.000 just did a 'thrust bearing' still meat on the clutch. Most likely failed due to contaminants, mud/water. Like TheoB I drive like a granny on road and save it for when i need it...
Forum: JK Wrangler Australia 29-09-2011
Replies: 9
Views: 1,581
Posted By Macca007
davidd, check all your wires to the sensors, i...

davidd, check all your wires to the sensors, i had an intermittent problem which i finally tracked down to the passenger rear and i found that the wires had got caught in my bump stop at some stage...
Forum: JK Wrangler Australia 19-07-2011
Replies: 18
Views: 2,505
Posted By Macca007
Where did you clear your defect, Vicroads or NSW?...

Where did you clear your defect, Vicroads or NSW? I don't think Vicroads can suspend another states rego? So a defect interstated wouldn't be worth the paper it's written on. For instance Vicroads...
Forum: JK Wrangler Australia 14-05-2011
Replies: 11
Views: 4,192
Posted By Macca007
I have just replaced both uni's after one of my...

I have just replaced both uni's after one of my end caps coming off and even though the cap came out because the circlip came off the reason it happened was the seals were all R/S, needle bearings...
Forum: AUSJEEP Supported Giveaways & Competitions 08-02-2011
Replies: 53
Views: 15,271
Posted By Macca007
Big Desert poser shot ...

Big Desert poser shot

http://i668.photobucket.com/albums/vv45/macca007/photo3a.jpg
Forum: JK Wrangler Australia 05-02-2011
Replies: 14
Views: 1,859
Posted By Macca007
my kids used to whinge when i took the top off,...

my kids used to whinge when i took the top off, too cold, too hot, too windy, too wet, solved that - go ride with mum!!! They don't whinge any more!
Forum: JK Wrangler Australia 05-02-2011
Replies: 14
Views: 1,859
Posted By Macca007
Locks all work, just the plug. And yes it is...

Locks all work, just the plug. And yes it is true, if the rear switches are not connected the front ones won't work I feel better now.
Forum: JK Wrangler Australia 05-02-2011
Replies: 14
Views: 1,859
Posted By Macca007
Heck, I would love half doors, the kids on the...

Heck, I would love half doors, the kids on the other hand.......................

Any thanks for your help, found the problem - the rear switch was unplugged. No, nothing recent, was at the...
Forum: JK Wrangler Australia 05-02-2011
Replies: 14
Views: 1,859
Posted By Macca007
I thought you were going to say "Your JK simply...

I thought you were going to say "Your JK simply thinks it's a JK"
Forum: JK Wrangler Australia 05-02-2011
Replies: 14
Views: 1,859
Posted By Macca007
Haven't done anything that i can think of, don't...

Haven't done anything that i can think of, don't use the rear windows much. The rear switches don't work either, I did a search on jk forum and some were saying that unless the rear switch is...
Forum: JK Wrangler Australia 05-02-2011
Replies: 14
Views: 1,859
Posted By Macca007
No go. Anything else before I pull the dash...

No go. Anything else before I pull the dash apart????
Forum: JK Wrangler Australia 05-02-2011
Replies: 14
Views: 1,859
Posted By Macca007
Yeah know about that one;) Thanks Jasper...

Yeah know about that one;)

Thanks Jasper I'll go and do that know, I assume you mean the ones at the doors?
Forum: JK Wrangler Australia 05-02-2011
Replies: 14
Views: 1,859
Posted By Macca007
Rear power windows not working

Done a search, couldn't find anything. So My windows don't work, there doesn't seem to ba a fuse associated to them. Fronts work fine, has any one had problems? Give me a place to look before I...
Forum: JK Wrangler Australia 10-01-2011
Replies: 4
Views: 1,150
Posted By Macca007
is that it ! I find a new one every time i clean...

is that it ! I find a new one every time i clean it
-behind the rear fog lights
-between the fuel tank and skid plate
-inside the front and rear guards
-behind the panel below that foam bit...
Forum: RumourMil 08-01-2011
Replies: 40
Views: 10,988
Posted By Macca007
They're not thinking at all. They are responding...

They're not thinking at all. They are responding to vocal minorities in the political spectrum. Just another reason to be careful who you vote for at your elections. Take the time to fill in the...
Forum: JK Wrangler Australia 11-12-2010
Replies: 958
Views: 530,628
Posted By Macca007
http://http://www.youtube.com/watch?v=xo7N7vA7p9k

http://http://www.youtube.com/watch?v=xo7N7vA7p9k
Forum: Off Topic Chitchat 13-11-2010
Replies: 21
Views: 2,864
Posted By Macca007
Now thats what I'm talking about!!!! My style of...

Now thats what I'm talking about!!!! My style of parking jeepology!!!
Forum: Off Topic Chitchat 11-11-2010
Replies: 21
Views: 2,864
Posted By Macca007
I tend to park them in, my passenger side to...

I tend to park them in, my passenger side to their driver side(if i'm on my own) leave them 6 inches to open their door and all they're going to hit are my rub rails or tyres. Hopefully makes them...
Forum: JK Wrangler Australia 07-11-2010
Replies: 36
Views: 4,268
Posted By Macca007
x2, check the bracket on the axle really well its...

x2, check the bracket on the axle really well its a known weakness
Forum: Question Polls 25-10-2010
Replies: 30
Views: 6,149
Posted By Macca007
Even waving to un modded JK's rarely get a...

Even waving to un modded JK's rarely get a return, generally don't notice other un modded jeeps but will always return a wave but will always wave to wranglers. Is that being 'Modelist'???
Showing results 1 to 20 of 63

 



All times are GMT +10. The time now is 02:13 PM.


Advertisements




AJOR does not vouch for or warrant the accuracy, completeness or usefulness of any message, and are not responsible for the contents of any message. The messages express the views of the author of the message, not necessarily the views of AJOR or any entity associated with AJOR, nor should any advice be substituted as technical advice replacing that of a mechanic. You agree, through your use of this service, that you will not use AJOR to post any material which is knowingly false and/or defamatory, inaccurate, abusive, vulgar, hateful, harassing, obscene, profane, sexually oriented, threatening, invasive of a person's privacy, religious, political or otherwise violative of any law. You agree not to post any copyrighted material unless the copyright is owned by you or by AJOR. The owner, administrators and moderators of AJOR reserve the right to delete any message or members for any or no reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold harmless AJOR, the administrators, moderators, and their agents with respect to any claim based upon transmission of your message(s). The use of profile signatures to intentionally mislead or misdirect any member on this forum is not acceptable and may result in your account being suspended. Any trip that is organised through the AJOR forum is participated at your own risk. If you or your vehicle is damaged it is your responsibility, not that of the person that posted the thread, message or topic initiating the trip, nor the organisers of AJOR or moderators of any specific forum. This forum and associated website is the property of AJOR. No user data is harvested and no information supplied in your registration will be sold for profit.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.

AJOR © 2002 - 2024 AUSJEEPOFFROAD.COM. All corporate trademarked names and logos are property of their respective owners. Ausjeepoffroad is in no way associated with DaimlerChrysler Corporation or Fiat Jeep.
www.ausjeep.com www.ausjeep.com.au www.midlifemate.com ausjeepforum.com www.r9kustoms.com
vB Ad Management by =RedTyger=