Quote:
Originally Posted by Auberon
That worm has a 1/8 inch pitch I believe making it an 8 tpi former. Considered making a form tool but couldn't justify it for only 4 units. Easy to turn in the lathe and wind as you would make springs in the lathe but oooooooh no. My time is worth more than that.
In a pinch you can leave the plastic piece in place and hold the window up (about 5mm from max height) with a 3/16 inch diameter set screw through the highest of the double holes in the zincalumed track. That allows a solution to be arrived at in due course.
Dastrix may I suggest you make sure it is the right one! given the changes that were implemented by Jeep in production and post production repairs....some are NLA and they have been replaced with earlier models ...etc A very complex story. Please be careful and read what Steiger say about this. With respect please proceed with caution before committing too many $'s.
|
The regulator from the inside of the door appears to look fine, so im not sure whats fine
Does anyone know the part numbers for the various models? Front Drivers side