Mode $06 report from Torque App

[4wd man]

Hi guys,
I have been playing with one of these OBD II EL327 scan tools on my JK and the test results for the Mode $06 report came up with some of these items. I then ran a check for fault codes and no faults came up. Can anyone tell me how to interpret these results? Thanks.

------------------
MID:$01 TID:$92
- O2 Bank 1 Sensor 1
Test incomplete or dependant test failed
--
MID:$30 TID:$2d
-
Max: 16,384 Min: 26,640
Test result value: 65,520
FAIL
----
MID:$35 TID:$83
-
Test incomplete or dependant test failed
--
MID:$41 TID:$98
- O2 Heater Monitor Bank 1 - Sensor 1
Test incomplete or dependant test failed
----
MID:$46 TID:$98
- O2 Heater Monitor Bank 2 - Sensor 2
Test incomplete or dependant test failed
--
MID:$81 TID:$90
- Fuel System Monitor Bank 1
Test incomplete or dependant test failed
--
MID:$90 TID:$2d
-
Max: 16,384 Min: 10,256
Test result value: 65,520
FAIL
----
MID:$f0 TID:$06
Lean to Rich sensor switch time(calculated) -
Max: 20,480 Min: 6,432
Test result value: 65,520
FAIL

[Jonny Jeep]

Don't take this as Gospel as it's just how I interpret it.

I suspect it's the emissions readiness status which some US states use for emissions testing. If a battery has been disconnected, or codes cleared, the system would indicate "not ready" as drive cycles need to be completed to test O2 sensors heaters and sensor operation, etc. If a "drive cycle" has been completed and all systems checked OK then the system would indicate "ready" meaning the emissions system checks out.

Test incomplete or dependant test failed would seem to indicate that your Jeep has not successfully completed drive cycles since battery disconnection or code clearing.

I have a ScangaugeII so here's how I can assess readiness...
http://www.scangauge.com/tips-and-tr...-scangauge-ii/

[4wd man]

Thanks for that Jonny.