Quote:
Originally Posted by Fishframe
Jeep Wrangler suspension is very fussy when you play with it and change geometrics. I’ve been through this. No amount of research will enlighten you. To get you started,
1. 2.5” lift. Did you install extended front sway bar links to compensate lift?
2. Wheel alignment is perfect?
3. Wheels properly balanced?
4. Tyre pressures correct and all consistent?
5. No worn rubbers underneath causing movement or vibration?
|
[mention]Fishframe [/mention]
Thanks,
1. Yes installed geometry correction, new end links and the complete terraflex 2.5” kit
2. Wheel allignment was perfect two weeks ago when it was done
3. Booked in tomorrow for a balance to rule that out.
4. All 4 are sitting at 34 psi, that was my first check
5. Checking the rubbers tonight to rule them as well. They didn’t say anything when the lift kit went in 2 weeks ago, so I’m assuming they are ok. But will confirm
Sent from my iPhone using Tapatalk