Hi, can anyone help me with a problem with this Motor. I have repaired the shaft on the flap that it operates but am not game to put the motor back in. when I try to line it up it is just a fraction out & when I switch on the ignition & fiddle with the control for the for the flap the Motor turns nearly 360 degrees. I am not game to fit it back on as I think it will snap the shaft again on the flap. the gear is only supposed to move about half to three quarters of a turn not 360 degrees.
It is the motor that changes the air from outside to recirculating inside ( I think )
Will a new Motor solve the problem ??
Thanks, Mike