high pressure fuel pump recall

[bjm]

Originally Posted by Mousie

I just checked the Z46 recall notice complete with attached spreadsheet of 43K vehicles VIN's listed and I see my vehicle is not listed MY14, there are a few engine numbers close to mine so I take it its not every Jeep? as in the HP fuel pump unit may be slightly different manufacture locations or suffix number differences. I was going to call this week but I think I will be knocked back.

I can not see how the hpfp on your vehicle would be any different ! I would contact Stellantis and ask them to put in writing why YOUR vin doesnt come up on the recall .! I would get the part and series number off your pump and do a bit
of research !

[FARWEST]

Agree with bjm Mousie....bit 'weird' your VIN isnt listed....all got the same Bosch CP4 pump...even my '12 biult MY13 is listed...got the recall notice a few months ago....no parts available at the time....loooong drive for me to a Dealership so will have to work that in with a visit to the 'big smoke'....still havnt had the 2nd FP Relay recall performed and not that 'keen' to let 'em disturb the 'backyard engineering job' I have put in place which has been 'ok' for a while now...3x spare Relays, Rubber tape and a 10mm spanner with nylock nuts for the 'handmade bracket' in wheel well are my 'fail safe'.......that wont help if the CP4 fails....nope.

ps: Just put my VIN back in to the MOPAR VIN Recall site and checked 'wording' on the Z46 recall dated June 09 2022...it states 'Some 2014-2020 Models'......odd....especially considering mine...as stated is a Dec.12 biult MY13....and IS listed, yet you state yours is a MY14 and it isnt listed....check it mate....just 'google' MOPAR VIN Recall....type in your VIN and 'all is revealed'

Further ps: Mine being listed and the Recall stating 2014-2020 is explained by the fact that the Diesels werent available in the U.S. prior '14...my bit sorted....Mousie, yours remains something to be solved

[drover]

Depending on the numbers being entered zero instead of OOhh, or a 1 instead of an I and the pdf search will say nothing found......... Ive tripped up on that a couple of times.

[Jeeper6]

Originally Posted by drover

Had a lookie, they are closer than we think Cricks Noosa about hour an half from me and Bundy jeep the same from your place ... I reckon you should go and get it done then let me know how it all went, and I'll head up, a day in Bundy would be nice, I could visit a relly ...

Thanks drover...didn't think to look if there was a closer Dealer to HB...I will check it out as Bundy is only an hour or so from here...keep you posted...

[Mousie]

Well there you go, the Australian site references its Excel document and lists the 43K vehicle VIN's affected yet that Mopar search site and manually entered VIN states incomplete for the Z46 so will be ringing tomorrow armed with this extra info. Sometimes I can understand a batch, build but as others said, its the common pump to all. I doubt I will get a knockback but at least I can confirm from the Mopar site its a recall. Yet another one of an ill prepared document and my bet is the Australian mail out will just do the excel doc and not the full suite of Aust delivered vehicles. Thanks for the additional info as will report back on the result. I don't have zero's in my VIN and secondly I kept doing partial searching on the spreadsheet to narrow down to the final three digits and sure enough, I am a few hundred away from the gaps in the document. Expect some gaps as they were a worldwide market of course.

[genpk]

when i got the car back, they gave me a work receipt with a list of work done-
new hp fuel pump, new hp fuel lines and new fuel filters.
I can confirm all those parts have been replaced!!

[junglejuice]

I’m wanting to get ours done shortly, booked it online with a request for confirmation but as yet it has been all silent.
I guess I’ll have to ring them directly!!!!