Drag Link For ZJ

[Davidp]

Ok guys my Drag ling is pretty stuffed so looking for either a good 2nd hand one that someone may have taken off for a big lift or a new one.

Any ideas where to get a new one and how much they cost? pity there is no upgrade may have to make one

[itsstock]

Davidp
First i would check your local auto spares shop, they might be able to get it aftermarket.
Because it has a ball joint in it a 2nd hand unit might be not much better than the original, remembering its a +10year old truck.

If you make a custom one up be sure to post the details.

i have ordered parts from these guys in the States(for my WJ/WG), after the order was confirmed it took about a week.
Postage on 2 tie rod ends(for drag link) where just under $60 (TRE where about $55)
Still saved about a $110 over getting them from the local stealership.
Might be able to get slower=cheaper postage. save a bit more $$$


http://www.jeep4x4center.com/jeep-st...herokee-zj.htm

[drover]

Try this place, better to ring as email can be a bit slow.

http://www.suburbanimports.com.au/jeepparts.htm