Nice one Warren, looks good, you bringing it to Camp Coffs to scratch it up
Well over the past few days we been working on mine with Michael and Jeremy.
So far we have
1. Replaced AMC 20 Carrier as pin was flogged out
2. Dedust and adjust on rear brakes
3. Replaced Oils in Engine, Diffs, Transfer Case
4. Replaced Drivers side engine mount (bit that bolts to chassis)
5. Replaced both axle unis in front axles
6. Got rotors ground, New Pads, Calipers rebuilt
7. Getting tie rod machined to take an adjuster like on drivers side so when they are stuffed i only have to change the TRE
8. Removed fuel pump and capped it off
9. Installed and connected up new Holley fuel pump
10. Wired up my driving lights
11. Put in new Tappet cover gaskets
12. Replaced gearbox mount
13. Replaced brake fluid
14. New seals and bearings etc in front diff (spindels etc)
15. New sway bar bushes
hmmm Think thats about it