Engine mounts
i have done 2 so far and they wont be the last(v-8 clevo's into jeeps),,,what i did was to put the motor in the chasis where i want it to sit,,i use a engine hoist to move it around and hold it up,,once i have it right i tack weld a piece of RHS to the harmonic balancer pulleys so as it sits across the chasis,,then i am able to remove the hoist(normally have my rear x member done by this),,both times i have used the original ford mounts,,just makes it easier when i need to replace them later,,the first time i used plate to make up the chasis mounts and the last time i used RHS,,as in the piccy below,,if u need more help just yell out....
paz [img]http://groups.msn.com/_Secure/0LgB0cPoOA0v!ToGmT*vOdzudWOYM26Kr!JP3dfr4OVc4WQSaP CxaOfn3O2F6xsrgBdr4AIr8r1g/Apr20_01.jpg[/img]
|