What did you do to your XJ today? 1M Views

[bruggz351]

Originally Posted by Mudmonster

I won one of these kits on ebay for $67 a lot bigger than I thought

http://www.ebay.com.au/itm/New-21-pc...item58b598c89f

I just ordered one of these.

If it does one set of joints, it's paid for itself.

Sent from my HTC_PN071 using Aussie Jeep Offroad mobile app

[Windex]

Originally Posted by anthonygubbin

intake vortex ring on the top of the tb means I don't have enough clearance between the intake elbow and the bonnet.

reagrds a

Ah ok, my LPG ring is inside the rubber intake elbow so I might try and fit it up. I never thought that it would have run into clearance issues, but then again everything under the bonnet has clearance issues.

[anthonygubbin]

Originally Posted by Windex

Ah ok, my LPG ring is inside the rubber intake elbow so I might try and fit it up. I never thought that it would have run into clearance issues, but then again everything under the bonnet has clearance issues.

As long as you can create a vortex it doesn't really matter how you achieve it. I might look in to some other options like yours so I can again run a TB spacer and maybe bore out the TB.


Regards A

[Windex]

Here is a little pic of mine from when I was installing my injectors, I removed the intake tube and moved it to the side.

[anthonygubbin]

Paid $350 labour for someone else to install a new trans adapter seal. Turns out only the seal was buggard, therefore no speedy sleeve required. Also found out I could have used grease on the seal instead of vas, which the latter I didn't have. So silly me thought best use trans fluid in case grease mess' with the dx3. Did consider doing the job myself, again but was concerned about there maybe needing a speedy sleeve. What the hell its only money.........

Regards A

[mud_slut]

Originally Posted by Shiggins

Mudslut posted the 666 post.

Do I win a prize ?

[Shiggins]

Someone should send you iron Maiden number of the beast.